Saturday, February 28, 2009

Removing the Keel from a Potter 15

Today we removed the keel from the Potter 15.  It was a bit more difficult that I had hoped, but not really all that hard.  I had hoped I could just slide the boat back on the trailer and then lower the keel enough to get it out.  But the rollers on the trailer were so stiff that the boat would not budge!  I knew I needed new rollers and new bunk carpeting, so I decided to try and get the boat off the trailer.  This will give me a chance to work on the trailer while I am waiting for the keel to get back from the galvanizer.

Step One:  Lower the trailer tongue and block up the back of the boat.  When you raise the tongue back up, the back of the boat will be off the trailer.

Step Two:  Raise the tongue high and block up the front of the boat, leaving room for the trailer to get out.  After you slide out the trailer, add some more blocks and support for the boat so that it is secure.

Step Three:  Position one person inside the boat, and one person under the boat.  Lower the keel until it touches the ground, then disconnect the line and hardware.  Together you can lift the keel off the pin, and pull it up and forward inside the cabin.  It weighs about 80 pounds, and in the confines of the Potter 15 cabin it is a bit tricky.  I left that up to a young friend with a strong back (thanks David).

The next step will be to take the keel to the galvanizer in Ballard.  They will strip off all the old coatings in an acid bath and then hot-dip galvanize it.  I am estimating it will cost about $75 for the process if I can talk one or two more people into taking theirs in at the same time.  

1 comment:

  1. Thanks...
    for the explanation of how you put your boat on blocks. Now, I think I can do it if I ever need to.

    Tommy- Dim Sum (WWP 15)